- ページ 17

カー・アンプ Directed Electronics D600のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics D600 20 ページ。 Dei orion d600: user guide

ページを印刷する

Connections and the Troubleshooting Tips sections of this manual to solve

your installation problems.

Step 6

Check to make sure the output for each channel is correct. If the active

crossovers are used, check to make sure that each output is correct from the

amplifier. When using active crossovers on midrange and tweeters, do not

use crossover frequencies lower than recommended. If the system is not con-

figured properly, refer to the Internal Crossover Configuration section of this

manual and take corrective action.

Step 7

If the output is clear and undistorted, continue to the Adjusting the Sound

of the System section of this manual.

Adjusting the Sound of the System

Once you have checked the system's operation, adjust the sound of the system. Adjusting

the sound of the system is accomplished by setting the level controls and adjusting the

internal crossovers.

Step 1

Turn the signal source volume control all the way down. Set any tone con-

trols to their flat or defeated positions. This includes the loudness control.

Step 2

Turn the level controls of the amplifier to their minimum positions.

Step 3

Choose music with high dynamic content that you like, with which you are

familiar, and will be used most often in the system.

Step 4

Turn the source unit's volume control up to its highest undistorted output

level. If you lack test equipment, this point occurs between 3/4 to full volume

depending on the quality of your source unit. Listen for any audible distor-

tion. If any distortion is audible, reduce the volume of the source unit until

you have an undistorted output. Leave the volume control at this position

during your system tuning.

Step 5

While listening to your chosen dynamic music, turn up the level control cor-

responding to the midrange output until you hear slight distortion and turn

the level control back slightly for an undistorted output. Depending on your

system, the midrange and tweeter output may be on the same output chan-

nels.

Step 6

Turn up the level control corresponding to the tweeter output until you hear

slight distortion and turn back the level control slightly for an undistorted

output. Depending on your system the midrange and tweeter output may be

on the same output channels.

Step 7

Fine-tune the output level between midrange and tweeters. Refer to the

Internal Crossover Configuration section of this manual for detailed instruc-

tions.

Step 8

Repeat Steps 5-7 for the rear speakers. If you do not have rear speakers con-

tinue to Step 10.

Step 9

Set levels between the front and rear midrange and tweeters for optimum

front/rear balance.

Step 10 Turn up the level control corresponding to the woofer output until you hear

slight distortion and turn back the level control slightly for an undistorted

output.

Step 11 Fine-tune the output level between satellite speakers and the woofers. Refer

to the Internal Crossover Configuration section of this manual for detailed

instructions. If using an RGC-1, adjust the level to the output of the woofer

to match the sonic requirements of the system.

Step 12 Enjoy your awesome Orion sound system.