- ページ 6

カー・アンプ Directed Electronics Xtreme XA-8001のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics Xtreme XA-8001 20 ページ。 Directed electronics amplifier owner's manual

ページを印刷する

FRONT PANEL CONNECTIONS/CONTROLS—

XA-3002/XA-6002

N N O O T T E E : : The numbers listed below are referenced on the Input Wiring Diagram.

1. P P W W R R (LED blue) - when illuminated

indicates that the amplifier is on.

2. H H I I I I n n p p u u t t (high level input) - Accepts

1v to 10v input from the headunit's

speaker output. The amplifier will

automatically wake-up when the

input is greater than 1V.

3. R R C C A A I I n n p p u u t t s s - accepts RCA input from a

source unit, preamplifier, or equalizer.

4. L L e e v v e e l l C C o o n n t t r r o o l l - continuously adjusts

from 150mV to 5V for full power

output.

5. C C r r o o s s s s o o v v e e r r S S w w i i t t c c h h - activates low

pass crossover, full (all pass), or

high pass crossover.

6. L L o o w w - - P P a a s s s s F F r r e e q q u u e e n n c c y y C C o o n n t t r r o o l l - adjusts

the frequency (50Hz–500Hz) of

the lowpass crossover.

7. H H i i g g h h - - P P a a s s s s F F r r e e q q u u e e n n c c y y C C o o n n t t r r o o l l - adjusts

the frequency (50Hz–500Hz) of

the highpass crossover.

8. B B a a s s s s - sets the bass boost of the

high-pass crossover to 0, 5 or 12dB

of boost.

9. P P R R T T (LED red) - illuminates when

the PRT (Protection) function is

active. Activates to protect the

amplifier when the temperature is

too high, the output has a DC

offset, a short was detected on the

output, or the amplifier power

cables have been improperly

connected (reverse power). If the

temperature, DC offset, or short

condition has cleared after approxi-

mately 10-seconds the amplifier

will automatically recover.