- ページ 8

ソウ Clarke 6470168のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6470168 17 ページ。 Abrasive cut-off saw

BEFORE CUTTING

LOCKING THE ARM

To unlock the saw and raise the

motor arm.

1. Push down on the handle.

2. Pull the locking pin out slightly to

unlock the motor arm.

3. Release the pressure on the

handle.

• The motor arm will then raise

into position.

• When locking the motor arm down for storage push down on the

handle, push the locking pin in and release pressure on the handle.

1. The vice is provided with a quick

release lever (A).

2. Lift the quick release lever to

release the screw so that the vice

clamping plate (B) may be

quickly moved into contact with

the work.

3. Flip the quick release lever back

into position and tighten the vice

to hold the workpiece.

The adjustable backplate can be adjusted backwards/forwards and to a

chosen angle to accommodate different size of workpiece.

1. Use the wrench provided to loosen and remove the two bolts (C).

2. Adjust the angle stop to the desired position.

3. Tighten the bolts securely before use.

MATERIAL CLAMPING AND SUPPORT

• Angle iron should be clamped and cut with both legs resting against

the base of the saw.

• A spacer block slightly narrower than the workpiece can be used to

raise the workpiece if required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]