- ページ 4
ソウ Clarke CBS-12WBのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Clarke CBS-12WB 14 ページ。 12" wood cutting bandsaw
ページを印刷する
ASSEMBLY
Installing The Table
Apply a coat of automobile wax to the table
top and inside surfaces of trunnion that
slide on frame.
1. Loosen the guide bar lock knob and position
the upper guide assembly all of the way up.
Tighten lock knob.
2. Locate two knobs and two washers in loose
parts bag, and the table assembly.
3. Place table assembly onto band saw frame with
the trunnion against mounting rib, in frame.
Hold table assembly against the frame and
install two (2) table lock knobs and washers
as shown through the trunnion slots and
tighten.
4.
Locate bevel indicator and pan cross hd.
screw in loose parts bag.
5. Install bevel indicator and screw as shown
using a phillips screwdriver.
-4-
Replacing
The Blade
1. Loosen the guide bar lock knob and position
the upper guide assembly approximately one
inch above the table and tighten lock knob.
2. Loosen the two blade guard mounting screws
and remove the blade guard.
3. Loosen the guide bar lock knob and position
the upper guide assembly approximately two
inches above the table as shown and tighten
the lock knob.
4. Remove table insert, truss head screw,
washer and wing nut from the table (See
Assembly, "Adjusting the Table"). Replace
these parts after the blade is installed,
tensioned and tracked.
5.
Loosen the two screws in the front of the
upper blade guide assembly that secure the
blade guides and separate them about 1/8".
6. Loosen the two screws in the side of the upper
guide assembly and slide guides and, thrust
bearing all of the way back. Tighten all
screws.
-5-