- ページ 8

ソウ Clarke CCO14のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CCO14 11 ページ。 355mm (14") abrasive cut-off saw

OPERATION

Ensuring the workpiece is properly clamped, and observing all precautions

previously mentioned, switch ON by pressing the safety lock button before pulling

the ON/OFF trigger switch upwards. Allow the wheel to reach full speed then

gently lower it on to the work. DO NOT try to cut too harshly.

The switch is a 'dead man' type and the motor will stop therefore, when it is

released.

NOTE:

Take great care when cutting with a new wheel. DO NOT press too heavily

particularly at the end of a cut.

Before use, always check the condition of the Abrasive Disk to ensure there are no

cracks or badly pitted edges. If in doubt, you must renew the wheel.

Always keep the machine clean and dry. Brush away dust and metal chippings.

Changing the Abrasive Disk

IMPORTANT!

Ensure the replacement disk is rated above

the rated speed of ther machine.

Having disconnected the power supply,

Raise the Upper Blade Guard, by hand, as

high as possible, then slide the bar, arrowed

in fig.6, across, so that it retains the Blade

Guard in place, as shown.

Slacken off the two screws which secure

the Abrasive Disk Centre Bolt access plate,

shown in fig 6, and remove the plate.

(Ref. Fig. 1)

Fig.7

Using the 8mm Hex. wrench, undo and remove the

Abrasive Disk Centre Bolt, then remove the washer,

and flange. Finally, carefully remove the Abrasive

Disk.

Reassemble in reverse order, ensuring the Disk, and

flange are correctly mounted on the flats on the

shaft with the flange and washer oriented as shown

in fig.7, Take great care not to over tighten the

centre bolt.

Fig.6