- ページ 5

ソウ Clarke CPS160のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CPS160 17 ページ。 160 mm plunge saw

6. Dress properly. Do not wear loose clothing or jewellery. Keep your hair,

clothing and gloves away from moving parts. Loose clothes, jewellery or

long hair can be caught in moving parts.

POWER TOOL USE AND CARE

1. Do not force the power tool. Use the correct accessories for your application. The

correct power tool will do the job better and safer at the rate which it was designed

for.

2. Do not use the power tool if the switch does not turn it on and off. Any

power tool that cannot be controlled with the switch is dangerous and

must be repaired.

3. Disconnect the plug from the power source before changing accessories,

or storing power tools. Such preventive safety measures reduce the risk of

starting the power tool accidentally.

4. Store idle tools out of the reach of children and do not allow persons

unfamiliar with the power tool or these instructions to operate it. Power tools

are dangerous in the hands of untrained users.

5. Maintain power tools. Check for misalignment or binding of moving parts,

breakage of parts and any other condition that may affect the power

tool's operation. If damaged, have the power tool repaired before use.

Many accidents are caused by poorly maintained power tools.

6. Use the power tool and accessories in accordance with these instructions

and in the manner intended, taking into account the working conditions

and the work to be performed. Use of the power tool for operations

different from intended could result in a hazardous situation.

7. The performance of this tool may vary, depending upon variations in line

voltage. Extension cable usage may also affect performance.

SERVICE

1. Have your power tool serviced by qualified service personnel using only identical

replacement parts. This will ensure that the safety of the power tool is maintained.

CIRCULAR SAW SAFETY WARNINGS

CIRCULAR SAW - CUTTING PROCEDURES

a. Keep hands away from cutting area and the blade. Keep your second hand on

the auxiliary handle, or motor housing. If both hands are holding the saw, they

cannot be cut by the blade.

b. Do not reach underneath the workpiece. The guard cannot protect you from the

blade below the workpiece.

c. Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth

of the blade teeth should be visible below the workpiece.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]