- ページ 4

ソウ Clarke CSS 300のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CSS 300 11 ページ。 Woodworker 13" scroll saw

20. MAKE WORKSHOP CHILDPROOF. Cover the saw adequately when not in use, to prevent

children from damaging themselves by tampering with it.

21. NEVER STAND ON THE MACHINE. Serious injury could occur if the machine is tipped or if a

cutting tool is accidentally contacted. Do not store materials above or near a machine, such

that it is necessary to stand on the machine to reach them.

22. HANDLE WITH EXTREME CARE Whenever transporting or installing machinery, and always

use a lifting tool.

23. AVOID ACCIDENTAL STARTING. Ensure the switch is OFF before plugging in to mains.

24. BE AWARE that accidents are caused by carelessness due to familiarity. ALWAYS concentrate

on the job in hand, no matter how trivial it may seem.

Wear safety goggles as protection against flying wood chips and saw dust. In many cases, a

full face shield is even better protection. A dust mask is also recommended to keep saw dust

out of your lungs.

The scroll saw must be bolted securely to a stand or workbench. If the saw has a tendency to

move during certain operations, bolt the stand or workbench to the floor.

A solid wood workbench is stronger and more stable than a workbench with a plywood

table.

This scroll saw is for indoor use only.

Do not cut pieces of material which are to small to be held by hand.

Clear the work table of all objects except the workpiece (tools, scraps ,rulers etc.) before

turning the saw on .

Make sure the blades' teeth are pointing down, toward the table, and that the blade tension

is correct.

When cutting a large piece of material, support it at the height of the table.

Do not feed the workpiece through the blade too fast. Feed only as fast as the blade will cut.

10. Keep your fingers away from the blade. Use a push stick as you near the end of the cut.

11. Take care when cutting a workpiece which is irregular in cross section. Moulding for example

must lie flat, and not 'rock' on the table as it is being cut. A suitable support must be used.

12. Take care when 'backing off' a workpiece from the blade, as the blade may bind in the 'kerf'.

In this event, switch OFF the machine and disconnect from the supply. Wedge open the kerf,

and withdraw the workpiece.

13. Switch off the saw, and make sure the blade has come to a complete stop before clearing

sawdust or off-cuts from the table.

14. Make sure there are no nails or foreign objects in the part of the workpiece to be sawn.

15. Be extra cautious with very large or small, or irregularly shaped workpieces.

16. Set up the machine and make all adjustments with the power OFF, and disconnected from

the supply.

17. DO NOT operate the machine with the covers off. They must all be in place and securely

fastened when performing any operation

18. Be sure to use the correct blade size and type.

19. Use ONLY approved replacement saw blades. Contact your local CLARKE dealer for advice.

The use of inferior blades may increase the risk of injury.