- ページ 11

ソウ Clarke CSS 400のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CSS 400 14 ページ。 400mm (16") scroll saw

ページを印刷する

MAINTENANCE

Apply a thin coat of paste wax on the work table from time to time. This will help the wood

glide across the table more smoothly.

After every 50 hours of use, lubricate the upper and lower arm bushes with SAE 20 oil, by

removing the hex. socket head screws (item 8)

The motor is permanently lubricated. Do not try to oil the motor bearings or service any

internal parts of the motor. If the power cord is worn, frayed, cut or damaged, replace it. Do

not try to patch it up with electrical tape this could lead to more trouble.

TROUBLESHOOTING

PROBLEM

Breaking Blades.

Motor Will Not Run.

Excessive Vibration

(Some vibration is

inevitable when the

saw and motor are

running)

Blade Runout

PROBABLE

CAUSES

1. Incorrect tension.

2. Overworked (worn out) blade. 2. Reduce feed rate or replace

3. Wrong blade being used.

4. Twisting blade in wood.

1. Defective cord, plug or outlet.

2. Defective motor.

1. Improper mounting of saw.

2. Unsuitable mounting surface.

3. Loose table or table rubbing

against motor.

4. Motor mount is loose.

1. Blade holders not aligned.

2. Insufficient Blade tension

3. Dull Blade causing excesive

force to be used at workpiece

SUGGESTED REMEDY

1. Adjust blade tension.

blade.

3. Use narrow blades for thin

wood, wider blades for

thicker wood.

4. Avoid side pressure on blade.

1. Unplug saw, replace

defective parts.

2.Repairs MUST be made by a

qualified technician. Call

Clarke Service dept. for

advice.

1. See proper mounting

instructions (p5)

2. Replace plywood

workbench surface with solid

lumber surface.

3. Tighten table adjuster knob.

4. Tighten motor mount screws.

1. Loosen screws holding

blade holder to rocker arms.

Adjust position of blade

holders. Use metal strip

to verify alignment. Retighten

holder screws

2. Increase Blade tension

3. Renew Blade and correctly

tension.