- ページ 13

ソウ Clarke Metalworker CBS45MDのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Metalworker CBS45MD 19 ページ。 6” (152mm) bandsaw

5. CHANGING SPEED

When using your Bandsaw always change the blade speed to best suit the

material being cut. The material cutting chart in shown below.

With the power disconnected, loosen the Drive Belt Adjuster Bolt (item P) in

order to slacken the drive belt, then open the pulley cover and change the

position of the belt to gain the desired speed.

Re-tension the belt so that it may be depressed by 1/2" In the middle of its

longest run. When satisfied, lock the motor firmly.

Close the pulley guard cover.

Material

Stainless or

AlloySteel

Bearing Bronzes

Mild Steel,

Hard Brass

or Bronze

Soft Brass,

Aluminium and

other light materials

When the blade becomes worn or defective in any way it should be replaced

immediately. The following process details how to change the blade, and should

be carried out by a skilled technician only.

Once the blade has been replaced it is recommended that the blade is Run In for

a short period.

1. Ensure the machine is disconnected from the mains supply then raise the Arm

to its vertical position and lock in place using the lock provided (item T).

2. Undo the screws securing the blade guard cover (item44) andf hinge the cover

back. Remove also the blade guard attached to the Blade Guide assembly.

3. Turn the Blade Adjuster Knob anticlockwise in order to remove all tension from

the blade, allowing it to be pulled from the pulleys and from between the guide

bearings, paying due care to the sharpness of the teeth,

Speed (M/min)

Motor Pulley

Small

Medium

Large

Belt Groove used

Driven Pulley

Large

Medium

Small