ページを印刷する
SAFETY ADVICE
Make sure that you read, understand and comply with the following.
The following symbols appear on the unit.
ELECTRICAL SAFETY
• Regularly inspect the power cable / plugs to be used with this heater
and DO NOT use the heater if the power cable is damaged.
• Minimise the risk of electric shock by installing a RCCB (Residual Current
Circuit Breaker).
• Make sure that the voltage on the rating plate is the same as the
voltage of the power supply. If in doubt, consult a qualified electrician.
• DO NOT abuse any electrical cable used with this heater. NEVER use the
cable for pulling or unplugging the heater.
• Keep the cable away from sources of heat, oil, sharp edges or moving
parts. Damaged or tangled cables increase the risk of electric shock.
OPERATION
• The heater must only be used by persons who have read these
instructions and have been trained in its use.
• DO NOT obstruct the air inlet and outlet sections of the heater.
• DO NOT cover the heater.
• DO NOT touch the heater casing or grille when first switched off, as these
will be very hot and will take time to cool.
• DO NOT get the heater wet or use in areas of high condensation.
• DO NOT allow the power cable to touch hot surfaces.
• DO NOT connect other appliances to the same mains socket as the
heater.
• ONLY use the heater on a level surface.
• DO NOT use this heater with a programmable timer used to switch it on
automatically.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Hot
surface,-
do not
touch
Do not
cover
4
Read the
manual