- ページ 5
ヒーター Clarke 6926011のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6926011 13 ページ。 Halogen heaters
• Connect the GREEN & YELLOW coloured wire to the plug
terminal marked with a letter E or Earth symbol.
• or coloured GREEN or GREEN & YELLOW.
• Connect the BROWN coloured wire to the plug terminal marked a
letter "L" or coloured RED
• Connect the BLUE coloured wire to the plug terminal marked a letter
"N" or coloured BLACK.
If this appliance is found to be fitted with a plug which is moulded on to the
electric cable (i.e. non-rewireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the
correct replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local Clarke dealer.
FUSE RATING
The fuse in the plug must be replaced with one of the same rating and this
replacement must be ASTA approved to BS1362.
We strongly recommend that this machine is connected to the mains supply
via a Residual Current Device (RCD).
DEVIL 371PB & 371SPB 110VOLT HEATER UNITS
The 371 models MUST be connected to a 110 Volt, 1 phase 50Hz supply through
a suitably fused isolator switch. ON NO ACCOUNT MUST A 230V, 13AMP
(BS1363) PLUG BE USED.
NOTE: If a portable 110V transformer is used, make sure it has a rated
capacity sufficient to take the load of the heater.
In the event that the heater is hard wired into the electrical system, it must be
carried out in accordance with IEE regulations.
Any power supply provided by the user must be comparable with the power
cable supplied with the heater, and any additional cables should not be
allowed to cause a trip hazard.
If in any doubt, consult a qualified electrician. DO NOT attempt any electrical
repairs yourself.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5