- ページ 5

ツール Clarke 3110472のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 3110472 17 ページ。 6pc air scraper tool set

3. Use clamps, or vices to hold a loose workpiece. Failure to secure the

workpiece could result in personal injury.

4. Inspect the blades before use. DO NOT use if damaged.

5. ALWAYS wear a face mask when using the tool as protection from

airbourne particles. Avoid disturbing existing dust and minimise the

scattering of dust in the workplace environment. Take steps to control the

dust at the point of emission.

TRANSPORTATION AND STORAGE

1. NEVER carry the tool by the air supply hose.

2. NEVER carry the tool with your finger on the trigger.

3. When not in use the tool should be disconnected from the air supply and

stored in a dry place out of the reach of children.

4. Avoid storing the tool in environments where the temperature is below 0

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU

ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR

COMPRESSORS AND COMPRESSED AIR SUPPLIES.

Use only clean, dry, regulated compressed air as a power source.

Air compressors used with the tool must comply with the appropriate

European Community Safety Directives.

A build-up of moisture or oil in the air compressor will accelerate wear and

corrosion in the tool. ensure any moisture is drained from the compressor daily

and the inlet filter is kept clean.

If an unusually long air hose is required, (over 8 metre by up to 15 psi to

maintain air pressure at the tools), the line pressure or the hose inside diameter

may need to be increased.

For optimum performance it is recommended that a 3/8" I/D airline hose is

used.

A typical air line layout is shown below. If an automatic in-line filter/regulator is

used, it will keep the tool in good condition, but should be regularly checked

and topped up with oil. SAE 10 oil should be used, and the lubricator adjusted

to approx 2 drops per minute.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]