- ページ 9

ツール Clarke 3110472のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 3110472 17 ページ。 6pc air scraper tool set

4. Remove the current blade by sliding it out of the blade holder (B). Be

careful of the sharp edge.

5. Hold the blade only by the flat surfaces. Insert the selected blade into the

blade holder's slot and align the blade bolt holes with the screw holes.

Make sure the bevel is facing upward (same facing as the screws).

6. Insert a screw into a screw hole and hand-tighten. Repeat with the second

screw. You may need to shift the blade if the bolt holes are not aligned to

allow the screw to enter the bottom half of the blade holder. Tighten with

the hex key. DO NOT overtighten.

7. Reconnect the air hose and start the compressor.

8. Test the air scraper without load to ensure the blade is secure. Point the

blade at an unoccupied spot in case the blade is ejected.

OPERATION

1. Set up the compressor and re-set

the air pressure to the scraper.

2. Squeeze the trigger to start the

tool and the blade will vibrate.

3. Increase or decrease the blows/

minute by adjusting the airflow

regulator.

4. Place the blade firmly at an angle

between the surface and the

material you want to remove.

Slowly push forward so the blade slides over the surface while separating

the unwanted material.

5. Release the trigger to stop the tool. Brush off all debris and resume scraping

until the task is complete.

SCRAPING TIPS

• DO NOT use excess pressure on the blade. Let the tool do the work.

• Allow the blade to reach working speed

• Avoid overloading the scraper If it becomes hot during use. Stop

work for a few minutes while it cools down.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]