- ページ 13
屋外暖炉 Afterglow FW-CTGSQFPのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Afterglow FW-CTGSQFP 17 ページ。 Cottage 34 in square gas fire pit
Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignitor module located
on the control panel to access the battery compartment. The ignitor module requires one AAA size battery (See
Figure 18), BATTERY IS NOT INCLUDED.
WARNING:
1. Please observe proper polarity and use the correct battery type when placing or replacing the battery.
Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of time.
To prevent fire or explosion hazard when testing for a leak:
1.
Always perform the leak test as described below before lighting this appliance or each time the
cylinder is connected for use.
2.
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.
Conduct the leak test outdoors in a well-ventilated area.
4.
Do not use matches, lighters or a flame to check for leaks.
5.
Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak,
disconnect the propane supply. Call a gas appliance service shop or your local propane gas supplier.
cylinder-regulator connection (Figure 19)
BATTERY
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way
and hold. Continue to press the
ignition button for 15 seconds.
ON/MIN
4. If the burner does not light in 15
(ENC./MÍN.)
seconds, release the knob and it will
pop back out. Wait 5 minutes before attempting
to light the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn to "OFF".
INSTRUCCIONES DE ENCENDIDO
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado).
2. Gire la perilla de control del gas a "ENC/MÍN" (encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga presionada.
Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta
volverá a su posición hacia afuera. Espere 5 minutos antes de intentar
encender el quemador nuevamente, repita los pasos 1 al 3.
PARA CERRAR EL GAS
1. Presion ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado)
Figure 18
BATTERY
OFF (APG .)
M A X
( M Á X . )
1 AAA
IGNITOR
1.5V
( Encendedor )
gas valve-bellows connection (Figure 20)
13