- ページ 7

ツール Clarke CAT139のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CAT139 13 ページ。 Air hammers

2. Connect a suitable hose as shown.

3. Connect the other end of the hose

to the compressed air supply.

4. Turn on the air supply and check

for air leaks. Rectify any found

before proceeding.

• PTFE tape may be helpful for

sealing threaded connections.

5. Your air tool is now ready for use.

FITTING THE CHISEL

1. First remove the retaining spring

from the nose by unscrewing it.

• Use the inboard lug to gain

purchase.

2. Insert the chisel into the air

hammer as shown.

3. Replace the retaining spring as

shown.

• Use the lugs to tighten.

1. Hold the tool firmly, then bring the

tool towards the work at an angle

of approximately 60-70 degrees.

2. Pull the trigger with the chisel in

light contact with the work.

3. Move slowly across the work

surface. To remove scale, rust or

other contaminants, only a light

force should be required.

4. Release the trigger to stop operation, whilst maintaining contact with the

work.

NOTE: that the tool may impact briefly after the trigger is released.

NOTE: The retaining spring has a life expectancy, depending upon the

intensity of usage. It is recommended that you procure a spare

spring for use in the event of failure occurring during the course of

a particular job.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]