- ページ 4
ツール Clarke CSB20BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CSB20B 6 ページ。 Shot blast cabinet
Clarke CSB20B にも： ユーザーマニュアル (13 ページ)
ページを印刷する
FEATURES
The 3 cu ft cabinet is lit by a low voltage (12 volt) fluorescent tube. A transformer
is provided which should be plugged directly into the mains supply. The attached
cable is then plugged into the switchbox, mountred on the left side of the cabinet.
The switchbox contains the ON/OFF rocker switch.
We strongly recommend that this unit be used with a vacuum extraction device.
Air is extracted via a double filtration system from the facility at the right hand
side of the cabinet.
Please note that when vacuum extraction is used, air will be drawn into the cabinet
through the hole on the back panel of the unit. The hole is covered on the outside
with a filter plate, and housed within the plate is a foam filter, which must always
be in place. This is to prevent grit from being blown out, if/when the vacuum
extraction is NOT used.
The lid is provided with a double clear plastic window, the inner of which may be
renewed quickly and easily if it should become damaged by the sand blasting
action.
A variety of abrasive nozzles is supplied with the unit to produce a useful range of
power and grit densities to satisfy all requirements. The cabinet is designed for use
with dry abrasives ONLY. We recommend Aluminium Oxide (for cleaning steel)
and Glass Beads (for cleaning Aluminium).
It is necessary to provide a clean, dry air supply, capable of delivering a minimum
of 10 cuft/min at 100 lbf/in
2
. Please consult your air compressor manual, ensuring
you comply with all safety precautions regarding the use of air compressors, and
observe all necessary precautions when using compressed air.
SAFETY PRECAUTIONS
•
Ensure you comply with all precautions concerning the use of air compressors
and compressed air.
•
Ensure all air connections are secure.
•
Do Not use the machine if the rubber gloves are ripped or otherwise
unserviceable.
•
Ensure the clear plastic lid is firmly secured before pressing the trigger.
•
Keep the jet well away from the air inlet hose (from side panel to gun).
•
ALWAYS wear safety glasses. (Normal eye glasses are NOT safety glasses).
3
TROUBLESHOOTING
CAUSE
PROBLEM
Excessive dust
Air vent or airflow is
in cabinet
blocked
Abrasive media worn
Too much abrasive media
in the cabinet
Loose air line or fitting
connections
Uneven blasting
Too much abrasive media
action
inside cabinet
Abrasive damp
Moisture present inside
cabinet
Abrasive media worn
Inadequate
speed or
Pressure too low
inefficient blast
Static electricity
Dry weather conditions
present.
Excessive Media
Lid not secure
blown into
Air vent filter missing.
surrounding
atmosphere
when no vacuum
extraction is
being used.
REMEDY
Clean rear vent, and keep
vent away from any wall.
Replace abrasive media
Remove excessive media
Tighten fittings and make
sure air lines are secure.
Remove excessive media
Renew abrasive, or dry
thoroughly before use.
Check air line to ensure it is
free from moisture
Replace abrasive media
Increase inlet pressure and
ensure control valve is fully
opened
Leave the item to be
cleaned on the grid.
Secure lid with swivel clips,
and adjust them if
necessary.
Replace filter, or blank off
hole in rear panel
temporarily with masking
tape. (Remember to
remove masking tape when
using vacuum extraction.
8