- ページ 7

ツール Clarke X-PRO CAT170のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke X-PRO CAT170 13 ページ。

4. Turn on the air supply and check for air leaks. Rectify any found before

proceeding.

• PTFE tape may be useful for sealing threaded connections.

5. If required, connect an in-line mini oiler to the tool.

• A mini oiler helps to prolong the life of the air tool.

6. If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the airline connector or via the hose

at the nearest connection to the air supply.

7. Ensure the trigger is NOT depressed when connecting the air line.

USING THE NEEDLE SCALER

1. Hold the tool with both hands and bring towards the work at an angle of

approx. 60-70

trigger and allow the needles to come into contact with the work.

2. Moving slowly across the work surface, proceed to remove scale, rust or

other contaminants taking care not to damage the surface. Regulate the

air supply pressure and locking groove setting to adjust the performance of

the tool.

3. Release the trigger to stop operation, noting that the tool may run briefly

after the trigger is released.

DISCONNECTING THE AIR SUPPLY

1. Do not disconnect the compressed air supply hose until the air supply has

been shut down or isolated at the shut off valve and the compressed air

expelled by running the tool until it stops.

2. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

3. Once the pressure has been released, disconnect the air supply hose from

the needle scaler.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

. With the airline pressure set to 90 psi (621bar), squeeze the