- ページ 11
モニター Ctouch CL2M-75UHDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ctouch CL2M-75UHD 17 ページ。
ページを印刷する- 1. User Manual
- 2. Table of Contents
- 3. Important Information
- 4. Important Safety Precautions
- 5. Standard Accessories
- 6. Identification of Controls
- 7. Remote Control
- 8. Connections
- 9. Basic Operations
- 10. 2Meet Operating
- 11. Remote Meetings
- 12. Operating the Navigation Bar
- 13. Menu List
- 14. Troubleshooting
- 15. Specifications
Turning the CTOUCH interactive display on or off
1. Plug the power cord into an AC power outlet.
2. Press Power Switch on the CTOUCH interactive display.
3. Now the CTOUCH is in standby mode. Wait a moment until the power indicator lights up, then press
Note: Be sure to wait for a few seconds before pressing
4. Press
button again to turn off the CTOUCH and put the display in standby mode.
5. To cut off the power completely, press Power Switch on the back of the CTOUCH.
Note: If the VGA does not get any signal it will go into stand-by after two minutes, while others source does not get any signal it will go into stand-by mode after 10 minutes.
The first time installation
Connect to power source and turn on the screen, the below installation menu page will display on the screen.
Select desired menu
language, then press
START and go to the
next page.
button. If you promptly press
button then the CTOUCH interactive display may not respond or act wrongly.
Select location and
go to the next page.
button to turn on the CTOUCH interactive display.
Select energy save
mode and go to the
next page.
9