Lenovo IdeaTab A1000 Hardware Maintenance Manual
Removing and replacing an FRU
This section presents exploded figures with the instructions to indicate how to
remove and replace the FRU. Make sure to observe the following general rules:
1. Do not attempt to service any computer unless you have been trained and
2. Before replacing any FRU, review "FRU replacement notices" on page 25.
3. Begin by removing any FRUs that have to be removed before the failing FRU.
4. Follow the correct sequence in the steps to remove the FRU, as given in the
5. When turning a screw to replace an FRU, turn it in the direction as given by
6. When removing the FRU, move it in the direction as given by the arrow in the
7. To put the new FRU in place, reverse the removal procedures and follow any
8. When replacing an FRU, use the correct screw as shown in the procedures.
Attention: After replacing an FRU, do not turn on the computer until you have
made sure that all screws, springs, and other small parts are in place and none
are loose inside the computer. Verify this by shaking the computer gently and
listening for rattling sounds. Metallic parts or metal flakes can cause electrical
short circuits.
Attention: The system board is sensitive to, and can be damaged by, electrostatic
discharge. Before touching it, establish personal grounding by touching a
ground point with one hand or using an electrostatic discharge (ESD) strap
(P/N 6405959) to remove potential shock reasons.
26
certified. An untrained person runs the risk of damaging parts.
Any of such FRUs are listed at the top of the page. Remove them in the order
in which they are listed.
figures by the numbers in square callouts.
the arrow in the figure.
figure.
of the notes that pertain to replacement. For information about connecting
and arranging internal cables, see "Locations" on page 37.
DANGER
Before removing any FRU, turn off the computer, unplug all power cords
from electrical outlets, remove the battery pack, and then disconnect any of
the interconnecting cables.
ページを印刷する