- ページ 30

Lenovo TAB 2 A7-10F Hardware Maintenance Manual

Removing and replacing an FRU

This section presents exploded figures with the instructions to indicate how to

remove and replace the FRU. Make sure to observe the following general rules:

1. Do not attempt to service any computer unless you have been trained and

2. Before replacing any FRU, review "FRU replacement notices" on page 25.

3. Begin by removing any FRUs that have to be removed before the failing FRU.

4. Follow the correct sequence in the steps to remove the FRU, as given in the

5. When turning a screw to replace an FRU, turn it in the direction as given by

6. When removing the FRU, move it in the direction as given by the arrow in the

7. To put the new FRU in place, reverse the removal procedures and follow any

8. When replacing an FRU, use the correct screw as shown in the procedures.

Attention: After replacing an FRU, do not turn on the computer until you have

made sure that all screws, springs, and other small parts are in place and none

are loose inside the computer. Verify this by shaking the computer gently and

listening for rattling sounds. Metallic parts or metal flakes can cause electrical

short circuits.

Attention: The system board is sensitive to, and can be damaged by, electrostatic

discharge. Before touching it, establish personal grounding by touching a

ground point with one hand or using an electrostatic discharge (ESD) strap

(P/N 6405959) to remove potential shock reasons.

certified. An untrained person runs the risk of damaging parts.

Any of such FRUs are listed at the top of the page. Remove them in the order

in which they are listed.

figures by the numbers in square callouts.

the arrow in the figure.

figure.

of the notes that pertain to replacement. For information about connecting

and arranging internal cables, see "Locations" on page 40.

DANGER

Before removing any FRU, turn off the computer, unplug all power cords

from electrical outlets, remove the battery pack, and then disconnect any of

the interconnecting cables.