- ページ 17

カメラアクセサリー Nikon MD-11のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Nikon MD-11 18 ページ。 Motor drive
Nikon MD-11 にも：取扱説明書 (48 ページ), 取扱説明書 (19 ページ), 取扱説明書 (20 ページ)

TROBLESHOOTING

Your MD-12 has been designed to make motor drive pho-

tography as simple and trouble-free as possible. However,

should you operate the camera incorrectly or without clearly

understanding what you are doing, minor "hitches" may

occur. If this occurs, please follow the instructions below.

If the motor drive "jams" during operation, this usually

means that the controls have either been operated incorrectly

or in the wrong sequence, and the coupling mechanism has

disengaged. Should this occur, turn the MD-12's power

switch off and make one exposure with the camera's shutter

release button, remembering, in the case of the FM (Serial

No. below 3,000,000), to switch over to manual film advance.

You may find that the motor drive did not finish advancing

the film. If so, complete the film advance using the camera's

film advance lever, then press the shutter release button. Do

not advance the film. Switch the motor drive back on and,

in the case of the FM (Serial No. below 3,000,000), revert to

the motor drive mode. The motor drive should advance the

film ready for the next exposure. If this does not clear the

malfunction or you are unable to move the film advance le-

ver at all, do not try to force the controls. Turn the motor

drive off once more and simply remove the motor drive from

the camera. This will clear the tension in the film advance

mechanism, allowing you to advance or finish advancing the

film and make one exposure, again do not advance the film.

Reattach the motor drive and, in the case of the FM (Serial

No. below 3,000,000), switch to motor drive operation. When

you switch the motor drive back on, the film should then

advance one frame ready for the next exposure.

Should you trigger the motor drive with the shutter speed

dial set to "B" the absence of an "exposure complete sig-

nal" may result in the camera's mirror locking up and the

shutter remaining open. To restore normal operation in the

event of this happening, merely move the shutter speed dial

away from "B."

At all times during motor drive operation, the film advance

lever should remain flush with the back of the camera. If

you move it out to its stand-off position, the motor_drive

will stop. Returning the lever to its flush position will auto-

matically start the motor drive once more.