- ページ 17

カメラアクセサリー Nikon SB-102 osのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Nikon SB-102 os 36 ページ。 Speedlight

ページを印刷する

CONTROLS IN

DETAIL~~::::;-:;=~k::sens~or

un~it

SU-::---101

Nikonos III

Nikonos-V or Nikonos IV-A

---

Bracket

As indicated in the diagram there are two positions for

the bracket

screw

one for Nikonos-V

and

Nikonos

IV-A and another for the Nikonos III. To reposition the

bracket

screw,

unscrew

it,

then

screw it

back into the

hole or the threaded end of the bracket

slot

Once

screwed into

the bracket

slot,

the bracket

screw can

moved to any position.

The larger hole in the center allows the

sync cord

to be

connected through the bracket to the Nikonos III.

The small hole that goes completely through the bracket

is the

sensor

holder

socket

When a plastic frame

finder or optical underwater viewfinder is mounted on

the camera

accessory

shoe,

the optional

sensor

holder is used to attach the Sensor Unit SU-101 to the

speedlight

bracket. To attach

align the

sensor

holder

positioning pin

on the top of the bracket with the hole

Arm

To attach the arm to the joint

insert the arm position-

ing

screw

into the slot in the jOint from either

side.

Align the arm positioning

screw

with the arm positioning

index

on the joint by turning the arm 90°

After align-

ing the arm positioning

screw

with the arm positioning

index,

turn the joint lever

clockwise as far as it will go

to lock the arm into position

When the arm is attached

in this

manner,

the

speed

light's axis will always inter-

sect with the lens

optical

axis,

even

the flash head is

moved up or down on the arm

(Normally,

the joint is

locked at the top of the arm.) Before diving

sure

the

jOint knob

and jOint lever are locked

tightly.

To attach the arm to the bracket

turn the arm knob

counterclockwise as far as it will go to loosen it (the two

bracket pOSitioning pins on the bottom of the grip

will

be visible). Slide the open end of the bracket between

the arm knob and the

grip,

seat the two bracket posi-

attached

to the

bracket

with

the

sensor

holder.

in the sensor holder

;

then screw the knob clockwise

until it is tight.

The

small

hole on the underside of the bracket is the

tripod

socket

•

When the bracket and arm are attached to the Nikonos IVA certain

optical

finder models for

older

UW-Nikkor 15mm f12.8

lenses cannot

attached.

If this

presents

problem

for

you,

authorized Nikon

dealers and

service centers can

perform the necessary modification.

tioning pins in the two indentations on the

bracket,

and

turn the arm knob clockwise as far as it will go to lock

the bracket into position. The correct arm/bracket posi-

tion is with the two washers on the underside of the

bracket

the rubber side of the bracket facing up, and

the flat

side

of the grip perpendicular to the bracket.