- ページ 12

顕微鏡 Nikon Eclipse E600WのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Nikon Eclipse E600W 21 ページ。 Teaching head/multi teaching head

ページを印刷する

Assembly for the dual-viewing (face-to-face) model

Clamp for 2

Clamp for 1

Assembly for the dual-viewing (side-to-side) model

1 Check that the serial numbers on the two components (main observer section and

secondary observer section) of the teaching head S-S are identical. (If the numbers are

different, observation will be adversely affected. In this case, please contact your

dealer or nearest Nikon representative.)

2 Adjust the height of the support stand so that the main observer section and the

secondary observer section are horizontal. This step is facilitated by first adjusting the

support stand to an approximate height before attaching the stand.

3 When a pointer is going to be used, assemble the system so that the secondary observer

will be positioned on the right. If reversed, the pointer control section will be at the

rear of the microscope.

4 When mounting the attachment on the microscopes ECLIPSE E800 and E1000, or on

the inverted microscopes ECLIPSE TE300 and TE200, separately available

components are required.

Mounting on the ECLIPSE E400, E600 or E600W

Clamp for 3

Pointer mounting

surface

Clamp for 2

Nikon

Y-THF

JAPAN

0100001

Clamp for 5

Main observer

section

Place

horizontally

III. Assembly

Check that the

serial numbers of

Y-THF

Nikon

the teaching head

0100001

S-S are the same.

Clamp for 7

Secondary

observer

section

Clamp for 6

Height adjustment

clamp screw

Adjust to an

approximate height

and readjust later.

JAPAN

Upper surface should

also be horizontal.