- ページ 9

計測機器 Nikon ARROW ID 7000 VRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Nikon ARROW ID 7000 VR 23 ページ。

[Measurement]

Caution — Controls, adjustments or usage of procedures other than those specified herein may

produce negative effects or damage to your health due to laser radiation.

* Before measuring, be sure to confirm each mode setting.

* Please refer to each section on how to set each mode.

■ Adjusting diopter

Adjust the diopter to obtain a clear internal display in the viewfinder.

First, rotate the diopter adjustment ring counterclockwise until it comes to a complete stop.

Next, turn on the power and rotate the diopter adjustment ring back and forth until the internal

display comes into focus.

1. Turn on the power.

(Automatic power shut-off after approx. 8 seconds

unoperated.)

Immediately after power-on

Standby

3. Pressing the PWR button starts measurement.

After measurement, the result is displayed for approx. 8 seconds, then power automatically turns off.

If you press the PWR button during power-on, another measurement starts.

2. Aim at the target.

Position the target at the center of the

target mark.

Pressing the PWR button once starts single measurement, then displays the results.

Press and hold down the PWR button to start continuous measurement up to approx. 8 seconds.

During measurement, the measured result is displayed consecutively while the laser irradiation mark is

blinking. If you release your finger from the button, continuous measurement stops.

Press PWR button once

Standby

Press and hold down the PWR button

Example of measured

Example of measurement

distance display

failure

Single measurement

Continuous measurement