計測機器 Nikon Callaway iQのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Nikon Callaway iQ 2 ページ。 Nikon callaway iq laser rangefinder instruction manual
Nikon Callaway iQ にも：取扱説明書 (39 ページ), 取扱説明書 (28 ページ)

ページを印刷する

CALLAWAY IQ & X HOT LASER RANGEFINDERS BY NIKON

Below are pictures of the CALLAWAY IQ and the XHOT, both of which are very similar.

We've placed a white dot indicating exactly where (on the laser lens end of your IQ or

XHOT) to place the belt clip tab/3m VHB (Very High Bond) adhesive disk assembly.

Included with your Quick Clip there will be 3 of the belt clip tab/3M VHB adhesive disks

assemblies (2 spares), spare 3M adhesive disks and a few spare alcohol pads for

cleaning the spot on your CALLAWAY IQ & XHOT .

Using the included alcohol cleaning pad, clean the spot on your CALLAWAY IQ or

XHOT as shown in the picture and allow to completely air dry. This removes any oils,

sweat, grease and other yucky stuff so the adhesion is optimized. Peel the paper

backing off of one of the belt clip tab/3M adhesive disk assemblies. Carefully place the

belt clip tab on the same spot shown in the pictures. CAUTION: The belt clip tab/3M

adhesive disk assembly will want to stick immediately to whatever it touches so use

care when placing it on the spot and try not to touch the adhesive with your fingers.

Apply some pressure on the belt clip hook for about 30 seconds. Allow it to "set" for 48

to 72 before using your CALLAWAY IQ or XHOT on the Quick Clip. That will also

enhance the adhesive properties of the 3M adhesive disk.

VERY IMPORTANT NOTE: If you have followed these instructions "to the letter",

it is very nearly impossible to remove with your hands (you may draw blood) and

it certainly cannot loosen up when in routine everyday use on the golf cart with

the Quick Clip.

If you have any doubts at all about the strength, flexibility and holding power of

the 3M VHB adhesive, please click on the link below. If you have any trouble

opening it, simply right-click directly on the link then click on "Open Hyperlink".

Or you can also copy the link and paste it into your web browser address line:

https://www.3m.com/3M/en_US/company-us/all-3m-products/~/3M-VHB-Tape-

4991?N=5002385+3293223574&rt=rud

Removing the belt clip tab: Simply warm the adhesive with a hair dryer. The adhesive

will soften and you can peel off the belt clip tab, though it still won't be easy. Don't try to

re-use the 3M adhesive that you peeled off as it loses some of its adhesiveness.

Remove it and use a fresh adhesive disk. You can reuse the belt clip tab. Remove any

remaining adhesive and clean it with an alcohol pad or a clean cloth with a dab of

isopropyl (rubbing) alcohol. Carefully (see CAUTION above) place the fresh 3M

adhesive disk on the belt clip tab. If you have any questions or concerns, please don't

hesitate to call or e-mail us. also, always remember that if you aren't happy with the way

your CALLAWAY IQ or XHOT works with the Quick Clip, we'll refund your $$ in full.

Mike Owens

GPS Quick Clip Inc

Fax: 843-235-8405

Phone: 843-333-7453

[email protected]