- ページ 2

カメラフラッシュ Nikon autofocus speedlight SB-900のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Nikon autofocus speedlight SB-900 8 ページ。 Speedlight
Nikon autofocus speedlight SB-900 にも：データシート (2 ページ)

ページを印刷する

ADVANCED WIRELESS FLASH

USING Nikon's CREATIVE

LIGHTING SYSTEM

The Nikon SB-900, SB-700 or SU-800 Wireless Commander can

be used to control other SB-900, SB-700, SB-600 and SB-R200

Speedlight units wirelessly. Connected to any i-TTL compatible

camera's Hotshoe, the SB-900 or SB-700 (or SU-800 Wireless

Commander) functions as a "Master Flash Unit."

Setting the

Set the SB-900 to the Master mode by using the

Off/On/Remote/Master setting switch.

1. Turn the Off/On/Remote/Master switch while

holding down the button in the center.

2. Align the index on the Off/On/Remote/Master

setting switch to MASTER.

Setting the ﬂash mode, ﬂash output level compensation values,

and channel number on the master ﬂash unit

1. Press the Function button 1 on the Master

ﬂash unit to highlight "M".

2. Press the MODE button, then turn the selector

dial to choose the desired ﬂash mode, and press the OK button.

TTL Through the lens metering

Auto Aperture

M Manual

- - - No light output (although in M - - -

a preﬂash will occur)

3. Press the Function button 2, then turn the selector dial to

choose the desired ﬂash output level compensation value,

and press the OK button.

4. Press the Function button 1 to highlight Group "A".

Turn the selector dial to choose a group other than "A".

5. Repeat procedures 2, 3 above to set the ﬂash mode and ﬂash output level

compensation values of the remote ﬂash units in Group "A".

6. In the same way as with Group A, set the ﬂash mode and ﬂash output level

compensation values of the remote ﬂash unit in Group "B".

Note: After setting the output compensation value press OK

twice to reveal "Ch" above Function button 2.

7. Press the Function button 2, then turn the selector dial to set a channel

number, and press the OK button.

SB-900

as a Master Speedlight Unit