屋外ライト Clas Ohlson WSL-1005のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clas Ohlson WSL-1005 4 ページ。 Garden light
ページを印刷するGarden Light
Article no: 36-2069 • Model: WSL-1005
Garden light 35 cm high stainless steel suitable for
mounting on bushes, along walk paths or such.
Please read the entire instruction manual before using and
save it for future use. We apologise for any text or photo
errors and any changes of technical data. If you have any
questions concerning technical problems please contact our
Customer Service Department.
This box contains
1 instruction manual
4 lanterns
Transformer 12 V, 1700 mA
Cable (10 m) with 4x branched sockets
Area of use
•
The garden light is meant for indoor and outdoor use.
•
Recommended temperature range when using: -20°C to
+ 40°C
Safety Instructions
•
Directions and safety instructions must be followed.
•
Do not use the light in an environment where it could be
exposed to gas, steam or dust.
•
Never look directly into the light source; it could damage
your eyes.
•
Do not change or dismantle the product, the guarantee
is no longer valid if any parts have been dismantled or
modified.
•
Never use any sharp metal tools or other objects that
could scratch the lights surface, if scratched it could start
to rust.
•
Only let a qualified technician perform repairs, use only
original parts.
•
The garden light is not a toy! Keep children away from
the light.
•
Discard the light if damaged in any way.
GREAT BRITAIN For consumer contact, please visit www.clasohlson.co.uk and click on customer service.
ENGLISH
Assembly Instructions
Select a good location
Halogen lamp
12 V 5 W T15
12 V AC Transformer
Cap nut (1, 2 and 3)
5 Nut
1. Check that all the parts are in the box.
2. Select placement of the light and press down the spike
into the ground.
3. Connect the cable from the lantern to the socket of the
short branched cable. Press together so it is secured and
water protected. Do the same procedure with all lanterns.
4. Connect the free end of the cable to the transformer and
lock it with the nut on the cable.
5. Connect the transformer to a wall socket.
Note! The branching can be moved on the cable if wanted:
Unscrew the screw (4) that holds the branching together.
Move the branching on the cable and tighten the screw (hold
the nut (5) correctly on the backside of the branching so it
does not fall out.
Care and Maintenance
Carefully observe the safety instructions and the assembly
directions. Clean the lantern with a soft sponge and luke-
warm water with a little detergent when needed.
Replace light bulb
1. Unplug the transformer from the wall socket
2. Unscrew the three nuts (1, 2, 3).
3. Lift the top part and pull out the halogen lamp.
4. Replace with a new halogen lamp 12 V 5 W, type T15
Technical data
Model
Light source
Transformer
Height above ground 35 cm
Cable length
4 Screws
Disposal
Follow local ordinances when disposing of this product.
If you are unsure about how to dispose of this product
contact your municipality.
WSL-1005
12 V 5W, type T15
Prim. 230-240 VAC,
Sec. 12 VAC 1700 mA (IP44)
10 m