- ページ 3

掃除機 Dirt Devil UPRIGHT SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dirt Devil UPRIGHT Series 16 ページ。

Featherlite and Featherlite Softbaa

Featherlite with stretch hose

2. With cord hook to back, plice'iowir handle onto handle base. Push together firmly. lnsert longer screw (1%") into back of lower handle to secure, (Diagram 1).

3. Place upper handle onto lower handle, (Diagram 2).

4. lnsert clip on tool caddy into hole on back of upper handle, (Diagram 3). Bring tool caddy down to fit against handle. lnsert shofier screw (1") to secure caddy and handle

sections (Diagram 4).

Attach

Tools:

5. lnsert nozzle connector end of flexible hose into holder. Wrap flexiblehose to the other side. A) lnsert hose into holder on back of cleaner. B) Press sides of hose into place

on tool caddy, (Diagram 4).

lnsert extension wand and crevice tool into tool caddy. Attach 2-in-1 tool to clip on caddy. Push down to secure, (Diagram 5).

Note: Paper bag must be properly installed before operating.

8 8 '

m i

1. Quick Cord Release: ' T o release your cord without unwinding it, turn the tgp cord hook to the left or right. Your power cord will now pull off in one coil, (Diagram 1).

2. Keep the cord out of the way while you vacuum by snapping it into the storage clip on the back of the upper handle, (Diagram 2)

3. Plug cord into electrical outlet.

4. Step on the power switch to turn on the cleaner. Switch is grey and located on the base of the unit.

is the international symbol for power.

FLOOWCARPET CLEANING:

5. Release the handle. With your foot, depress the handle release pedal on the left side of the cleaning head, (Diagram 3).

6. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) depress the handle release pedal again to clean under low

furniture. (Diagram 4).

ABOVE FLOOR CLEANING: Cleaner must be in the locked upright position to lift the rotating brush off the carpet when cleaning above the floor.

Turn cleaner OFF before attaching or removing hose.

1. Snap cleaner into its upright position.

2. Lift door on the nonle and insert hose end with nonle connector until locked in position, (Diagram 5).

3. Pull the hose handle from side of cleaner.

4. Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose handle.

To remove hose from nonle, press latch on nozzle connector and pull up, (Diagram 6).

Note: Remove hose from nonle when cleaning carpets to insure proper cleaning performance.

CAUTION: Revolving brush continues to rotate while cleaner handle is in upright position. Avoid tipping cleaner or setting on furniture, fringed area rugs, or carpeted

stairs during tool use.