- ページ 10

掃除機 Dirt Devil Upright vacuum cleanerのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dirt Devil Upright vacuum cleaner 20 ページ。 Upright vacuum cleaner

ページを印刷する
Dirt Devil Upright vacuum cleaner オーナーズマニュアル
3.
2.
Return new filter to the dirt
Align tabs on lid with the
container lid. Push filter into
openings on the dirt container
place until it snaps to prevent
and twist to close and secure
leakage.
lid.
*Regular Maintenance: Each time the dirt container is emptied, the pleated filter should be cleaned. Tap the lid
firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use,
this will not affect the filter's performance.) Do not brush the filter. The cleaning instructions may vary depending
on the dirt conditions. In some cases, more or less cleaning of the filter may be required. It is recommended that
the filter Part # 3-UDO280-001 be replaced once per year.
BELT & BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT
OR BRUSHROLL.
BELT STYLE
For Belt Style 5 replacement, please visit our website at www.dirtdevil.com to buy
5
online or locate a dealer nearest you.
TO REMOVE BELT
1.
Lay cleaner flat and flip cleaner to expose
Rotate/pivot the nozzle guard
nozzle base. Base should lay flat and face
and pull off.
up. To remove nozzle guard, use Phillips
screwdriver to remove the three (3)
screws. Arrows show location of screws.
TO REPLACE BELT OR BRUSHROLL
1.
Slide belt onto motorshaft.
MOTOR
SHAFT
4.
Return dirt container to cleaner.
Align slot on bottom of dirt
container with tab on cleaner.
Push to snap into place.
2.
3.
Lift and remove brushroll.
Dispose of old belt.
2.
Place new belt in area of
brushroll without bristles.
END CAP
10