- ページ 5

水ポンプ Armstrong H67のPDF 設置および操作方法をオンラインで閲覧またはダウンロードできます。Armstrong H67 10 ページ。 In-line ecm circul ating pumps

Input demand

There are two methods of setting the input demand using the

PerfectSpeed® User Interface box.

Table 3 – Input demand options

Input demand

Definition

setting method

Set with On-Board

The input demand can be set via the On-

Potentiometer

Board Potentiometer. An external input is

not necessary.

0V to 10V

When an external controller is connected,

Set with

the On- Board Potentiometer should be

control signal

set fully ccw (0%). Otherwise, the actual

demand seen by the pump is offset by the

setting of the On- Board Potentiometer.

Connection diagrams

There are two methods of setting the Input Demand. See Table

3 for definitions of the two options.

Table 4 – Setting input demands options

set with on-board potentiometer

set with 0 V to 10V DC control signal

In-line circulating

pumps

AC line connections

Check to see if the line voltage matches the nameplate voltage.

connections

green/verde screw

ground

Configuration scenarios

This section provides examples of different configurations and

briefly describes how the motor operates under those conditions.

Operating parameters

Speed will change linearly based on the On-Board Potentiometer

or remote 0V to 10V DC signal. The graph below illustrates the

operation of a motor adjusted with the On-Board Potentiometer.

At 0.5V DC signal, the motor will come on at 30 0 rpm and

ramp linearly to 18 0 0 rpm for ECM series circulators.

Adjusting pump speed (rpm) with on-board potentiometer

i n sta l l a t i o n &

o per at i n g i n str uct i o n s