- ページ 11

ティラー Dirty Hand Tools 103350のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Dirty Hand Tools 103350 16 ページ。 10” mini-cultivator

Pulling the safety

drive lever towards the

handlebar engages the

tines.

Figure 5

Operating Instructions

Remove the locking pin and reverse the depth regulator and wheels,

slide up or down to position at desired tilling depth and reinstall the

locking pin (see Figure 4).

On/Off

Make sure that the cultivator is on a level, stable position before starting

Switch

the engine. Do not start the engine if there is spilled fuel.

1. Turn the engine's ON/OFF switch to ON (see Figure 5).

2. Pump the engine primer bulb until it ﬁlls with fuel.

3. Turn the engine's choke lever to the CLOSED position. Set the

choke lever to the OPEN position only when the engine has

started or upon restarting a warm engine.

4. Pull the recoil starter handle slowly until you meet some

resistance. Pull the recoil starter with a rapid full arm stroke

allowing the starter rope to rewind slowly. Repeat as necessary

until the engine starts running.

5. After the engine warms up and starts running normally, move

the choke lever to the OPEN position.

Note: Allow the engine to warm up for 30 seconds before moving

the choke lever to the OPEN position.

e ﬁrst 25 hours of operation is the break-in period. Breaking-

in the Engine will help ensure proper equipment and engine

operation, and will extend the engine's lifespan. After the ﬁrst 25

hours of use change the gasoline/2-cycle oil fuel mixture.

LOCKING

DEPTH

REGULATOR

Figure 4