- ページ 15

ティラー Dirty Hand Tools 103350のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Dirty Hand Tools 103350 16 ページ。 10” mini-cultivator

ページを印刷する

Troubleshooting

PROBLEM

Engine will not start

Engine runs rough, oods during operation

Engine is hard to start

Engine misses or lacks power

Engine will not stop when throttle control

is positioned at stop

Cultivator is di cult to control when tilling

(machine jumps or lurches forward)

Tines do not rotate with Driver Safety Control Lever

depressed

Tines continue to rotate after the Driver Safety

Control Lever is released

Excessive heat build up in tine area

during tilling

SOLUTION

• Add fuel to fuel tank.

• Connect spark plug wire to spark plug

• Choke should be at start position for a cold start

• Clean or replace air cleaner

• Drain old fuel and replace with fresh. Make sure the

2-cycle oil to gas mixture is correct.

• Make sure spark plug wire is securely attached to

spark plug

• Drive safety control levers must be released to neutral

position to start the engine

• Choke is not in proper start position

• Raise the tines for shallow tilling by lowering the

depth regulator lever

• Remove and clean fuel tank

• Clean or replace air cleaner

• Improper carburetor adjustment, take to authorized

engine service center

• Replace spark plug and adjust gap

• Drain and re ll gas tank and carburetor

• See engine manual to check and adjust the

throttle linkage

• Push downward on the handlebars raising the tines

• Keep the tines raised slightly for shallower tilling on

hard soils, then do a second pass going deeper

• Raise the cultivator depth regulator

• Drive cable is damaged or incorrectly adjusted

• Drive belt is damaged

• Drive cable is damaged or incorrectly adjusted

• Clean the tine axle shaft

• Check transmission uid and ll if low