- ページ 3

洗濯機 Acorn Safety S0320-FPBのPDF 設置、操作、メンテナンスの説明書をオンラインで閲覧またはダウンロードできます。Acorn Safety S0320-FPB 7 ページ。 Pedestal eye/facewash

ページを印刷する

Installation & Operation

INSTALLATION INSTRUCTIONS:

Supplies required: (not provided by Acorn)

1. Floor fastener anchors, washers and bolts.

2. Pipe Sealant or Teflon tape for sealing water connections.

IMPORTANT: Flush water supply lines prior to

connection to safety equipment.

NOTES:

Top of spray nozzles must be between 33" - 45" from

—

finished floor in order to meet ANSI Z358.1.

Use hand tools and wrenches in a manner which will

—

prevent marring finished surfaces. Strap wrenches or tools

with plastic jaw linings are highly recommended.

Refer to Rough-in for location of supply and drain lines.

—

Fragments of Teflon tape or pipe sealant residue can

—

interfere with the proper operation of this unit. Ensure pipe

sealant methods do not cause contamination in the

system.

Prior to beginning assembly, TURN OFF water supply to 1-

—

1/4" potable water supply line.

STEP ONE: HYDRANT LOCATION

1. Determine location of eyewash equipment and ensure to

position equipment so that there is a minimum of 12" from

any wall or equipment around assembled unit.

2. Determine frost line and dig pit deep enough to

accommodate a minimum of 3 cubic feet of porous gravel

fill.

3. Test hydrant for functionality before permanent placement.

Place hydrant in proper location per rough-in drawing

above. Hydrant valve body shall be buried within the

gravel fill to insure proper drainage from weep holes.

Connect customer supply line to hydrant and fill pit with 3

cubic feet of porous fill.

4. Back fill pit and create a concrete pad large enough for

anchoring eyewash unit. Once concrete has completely

cured, follow anchoring hardware instructions in step two.

STEP TWO: PEDESTAL

1. While holding the eyewash assembly (A) in position, mark

mounting hole locations.

2. Remove flange assembly and install appropriate floor

anchors to receive mounting bolts (supplied by others).

3. Re-position assembly and install with mounting bolts and

washers.

STEP THREE: HYDRANT CONNECTIONS

1. Connect hydrant (B) to eyewash (A) assembly using 5/8"

OD x 3/8" NPTE compression adapter provided & proper

plumbing techniques to seal all made up threads.

Acorn Safety

a division of Acorn Engineering Company™

Manual #7109-214-001

Page 3 of 7

Date: 10/28/2013