- ページ 3

洗濯機 Acorn Safety S0430のPDF 設置、操作、メンテナンスの説明書をオンラインで閲覧またはダウンロードできます。Acorn Safety S0430 5 ページ。 Eyewash / facewash

ページを印刷する

Installation & Operation Manual

INSTALLATION INSTRUCTIONS:

Supplies required: (not provided by Acorn)

1. Wall fastener anchors, washers and bolts for eyewash

assembly.(Machine threads or lag bolts based on

construction.)

2. Wall fasteners.

3. Pipe sealant or Teflon tape for sealing water connections.

4. 1 ¼" slip joint p-trap / drain connection.

IMPORTANT

FLUSH WATER SUPPLY LINES PRIOR TO

CONNECTION TO SAFETY EQUIPMENT.

NOTES:

Top of spray nozzles must be between 33"- 45" from

—

finished floor in order to meet ANSI Z358.1

Use hand tools and wrenches in a manner which will

—

prevent marring finished surfaces. Strap wrenches or tools

with plastic jaw linings are highly recommended.

Refer to Rough-in for location of supply and drain lines.

—

Fragments of Teflon tape or pipe sealant residue can

—

interfere with the proper operation of this unit. Ensure pipe

sealant methods do not cause contamination in the

system.

STEP ONE: MOUNTING

1. Position assembly on wall at appropriate height and in

proximity to the supply and drain lines.

2. While holding the assembly level against the wall, mark

position of mounting bolt holes.

3. Remove assembly and install appropriate anchors into

wall to receive 3/8" diameter bolts (supplied by others).

4. Re-position assembly against wall and install 3/8" bolts to

secure the assembly to the wall.

STEP TWO: DRAIN LINE

1. Install sanitary drain line (supplied by others), if not

already done, in a position which will align with eyewash

assembly as shown in rough in.

2. Install 1 ¼" O.D. Tailpiece to assembly.

3. Connect Assembly drain tailpiece with a 1 ¼" slip joint p-

trap or elbow connection. (Supplied by others) to the

sanitary drain previously mentioned.

STEP THREE: SUPPLY LINE

1. Install water line (Supplied by others), in a position, to

align with ½" ball valve as shown in Rough- in.

2. Make connection to ½" NPTF ball valve with appropriate

fittings (Supplied by others)

NOTE: LARGE FITTINGS NEED TO BE AVOIDED IN THE

AREA AS SHOWN IN THE FIGURE TO THE RIGHT, TO

AVOID INTERFERENCE WITH VALVE PADDLE

ACTIVATION.

3. Open water supply.

4. Test for leaks, proper operation and flow.

STEP FOUR: SIGNAGE & INSPECTION

1. Position sign with clear visibility, in close proximity to

safety equipment and mark mounting hole locations.

2. Select appropriate ¼" anchors, screws and washers

(Supplied by others) to install signage.

3. Attach inspection tag supplied, with plastic zip tie.

Acorn Safety

a division of Acorn Engineering

Manual #7109-100-001

MOUNTING

SCREWS(PROVIDED

BY INSTALLER)

1 1/4" OD

TAILPIECE

MOUNTING

HARDWARE

(DETERMINED

AND PROVIDED

BY INSTALLER)

SANITARY

DRAIN LINE

& P - TRAP

(PROVIDED

BY INSTALLER)

AVOID INSTALLATION

OF PIPE OR FITTINGS

OVER 1" DIA. IN THIS

ZONE TO PREVENT

INTERFERENCE WITH

PADDLE ACTIVATION

Company

™

Page 3 of 5

45" MAX

33" MIN

HEIGHT

DETAIL A

SCALE 1:4

Revised: 07/23/13