- ページ 7

ディスク・デュプリケーター Disc Makers ElitePro1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Disc Makers ElitePro1 20 ページ。 Elitepro series cd-r/dvd-r publishing and printing system

ページを印刷する

Step 1

Unpacking the Hardware

Your system was shipped in three separate boxes. The larger box contains the

ElitePro unit, keyboard, mouse, and cables. The remaining two boxes contain

the monitor and Disc Makers Autograph on-disc inkjet printer. Please inspect

the contents and verify them against your packing slip. Be sure to report any

errors in shipping immediately.

Select a suitable location for your ElitePro. It should be level, clean, and free

from excessive vibration. Carefully open the largest box and remove the top

protection cardboard sheet. You will then be able to remove the following:

Next, by lifting straight upward, carefully remove the foam container and foam

protection over the ElitePro unit. You will see the ElitePro in a plastic bag. The

ElitePro has lifting handles on either side. Locate the lifting handles (see page

6) and remove the ElitePro from the box. Take the ElitePro out of the plastic

bag and place all shipping components back into the shipping carton.

Important: Please retain the original box and packaging in the event the unit

requires future servicing or you need to move the unit from one location to

another. This will help to reduce the possibility of damage occurring in transit.

Any item that needs to be returned for a warranty repair must be returned

in the original packaging. (See page 2.)

Remove the monitor and the printer from their shipping cartons. Proceed to

installation of the CD Pick arm.

Large box opened with parts

located in top section.

• CD pick arm

• Keyboard

• Mouse

• Printer control cable

• AC power cord

• Software and manual

Remove foam sections to access

the ElitePro unit.

www.discmakers.com

Locate the lifting handles (see

page 6) on the ElitePro unit and

lift out.

1-888-800-4041