- ページ 20

ソウ DISCO DAC552のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DISCO DAC552 20 ページ。 Automatic dicing/cutting saws

Safety precautions to be observed during operation

- Waterproof cover lock

- Circuit breaker lever lockout

When the machine power is ON and during spindle rotation, the

waterproof cover is locked. If the machine power turns OFF during

spindle rotation (by EMO switch activation, power failure, etc.), the

waterproof cover is locked and does not open even when the

machine is OFF.

If it is necessary to open the waterproof cover while power cannot

be restored, the cover lock cylinder has to be released. Performing

maintenance with the cover lock released may cause injury to the

personnel or damage to the machine. Maintenance tasks must be

carefully performed by the qualified personnel. While a maintenance

task is being performed, no one must touch the machine except the

maintenance personnel (for detailed interlock operation

descriptions, see section 7 of this chapter, [Interlock Mechanism]).

Before performing maintenance tasks with the machine turned OFF,

lock up the circuit breaker lever with a padlock or the like. Observe

this precaution to prevent irrelevant persons from inadvertently

touching the machine to invoke unexpected operations. For circuit

breaker lever lockout, perform the following steps:

1) Turn OFF the key switch, which is located at the right of the

monitor, and then take out the key.

2) Turn OFF the circuit breaker lever at the rear side of the

machine. As shown below, lock up the circuit breaker lever with a

padlock or the like.

[Standard (CE) version]

WARNING

[SEMI version]

A-6

Continued

Push the knob to the left.