- ページ 8
トリマー Cub Cadet CC 2000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cub Cadet CC 2000 20 ページ。 2-cycle trimmer
Cub Cadet CC 2000 にも： パーツリスト (2 ページ)
ページを印刷する
Section 3
Assembly
Shaft Grip
(4) Screws_
Shaft
Housing
Minimum 6 inches
(15.24 cm)
D-Handle
Bottom Clamp
®
(4) Nuts
Fig. 3-1
Fig. 3-2
_-_(4)
Screws
J
On some units, the D-handle may be preinstalled and
only require loosening the screws and adjusting the
D-handle to the operator. Go to step 4 for adjusting the
D-handle if preinstalled.
INSTALLING
AND ADJUSTING
THE D-HANDLE
1.
Remove the screws, nuts and bottom clamp piece
that were installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto
the bottom clamp (Fig. 3-1). Place it a minimum of
6 inches (15.24 cm) from the end of the shaft grip.
3.
Hold each hex nut in the bottom clamp recess with
a finger. Start screws with a screwdriver. Do not
tighten until you make the handle adjustment.
4.
If it was preinstalled, loosen the screws on the
D-handle just enough to move the D-handle.
5. While holding the unit in the operating position
(Fig. 3-2), position the D-handle to the location
that provides you the best grip.
6. Tighten the clamp screws evenly, until the D-handle
is secure.
INSTALLING
THE CUTTING
ATTACHMENT
SHIELD
Use the following instructions
if the cutting attachment
shield on your unit is not installed.
Shaft
Housing
_-
Cutting
Attachment
Cutting
Attachment
Shield
W
, =
:
k
_'
Never operate the trimmer
without the cutting
attachment
shield in place to prevent serious
personal
injury.
1.
2.
.
Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 3-3).
Push the cutting attachment
shield down to the top
of the cutting attachment
assembly and then rotate
the cutting attachment
shield until the screw holes
align and the guard fits into the recessed pocket
(Fig. 3-3).
Install the four (4) screws with a Phillips screwdriver
(Fig. 3-4).
8