- ページ 14

芝刈り機アクセサリー Cub Cadet 19A40002100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cub Cadet 19A40002100 20 ページ。 Triple rear bagger

Rotate the chute around the deck so that its front edge fits

snugly into the deck opening. Lower the chute deflector

slowly (C in Fig. 4-21).

Attach the retainer strap on the discharge chute to the

retainer clip on the deck. Refer to Fig. 4-22.

Note: For the chute elbow to be properly installed, the bottom

edge must fall below the bottom of the deck opening and the

tab on top of the elbow should rest above the deck opening.

Install the chute adapter onto the chute elbow by lining up

the tabs and sliding the adapter over the chute elbow, as in

Fig. 4-23. Secure the chute adapter by installing two ratchet

clips (726-3046), included in hardware pack 689-00163, into

the holes provided.

4 — a

ectiOn

sseMbly

Figure 4-22

Figure 4-23

& i

nstallatiOn

Peel the backing off of the self-adhesive foam strip (721-

04388) that has been included with your grass collector.

Apply it to the upper chute, flush against the flange as

shown in Fig. 24.

Flange

Figure 4-24

With the bagger cover open, install the upper chute over

the chute adapter, and rest the top so that the chute

support sits in the upper chute groove. See Fig. 4-25.

Note: Make sure to align the upper chute with the ridges

on the bagger support bracket, as shown in the inset of

Fig. 4-25.

Figure 4-25