- ページ 9
池のポンプ Blagdon AMPHIBIOUS A3000のPDF リーフレットをオンラインで閲覧またはダウンロードできます。Blagdon AMPHIBIOUS A3000 16 ページ。
ページを印刷する
- 1. Table of Contents
- 2. Getting to Know Your Amphibious Pump
- 3. Pump Performance / Flow Charts
- 4. Technical Specifications
- 5. Installation
- 6. Electrical Installation
- 7. Maintenance and Cleaning
- 8. Cleaning
- 9. Routine Maintenance
- 10. Monthly Maintenance
- 11. Annual Maintenance
- 12. Winter Storage
- 13. Troubleshooting
- 14. Faults - Problem Procedure
- 15. Consumer Advice Contact Details
- 16. Guarantee
Amphibious Pump Leaflet 2.qxd
Locating your Amphibious Pump
The Amphibious pump should be located on a firm and level base in the
pond/water feature in a depth of at least 10cm, but no more than 4m.
It is advisable to keep the pump off the bottom of the pond to avoid silt
entering the pump causing excessive wear and increasing pre-filter cleaning.
!
Never run the pump out of water as this may cause irreparable damage.
Fountain
Make sure there is ample cable from mains supply. Place pump in desired
location. Adjust telescopic riser pipe so fountain head is above surface of
the pond. Fountain height can now be adjusted, see "Adjusting dual control
T-piece" diagram below. The fountain ball joint can be used to adjust for uneven
pond floors ensuring the fountain display is kept vertical and within the pond.
See "Getting to know your Amphibious pump" fittings for parts and descriptions.
ADJUSTING DUAL CONTROL T PIECE
AND TELESCOPIC RISER PIPE
Adjust height by unlocking collar then
1
pushing or pulling 30cm telescopic riser
pipe (see "Getting to know your
Amphibious pump" for parts descriptions).
Optional additional 20cm extensions can
be added to increase the height.
OUTLET FLOW
2
CONTROL VALVE
Supply water features, waterfalls and filters
by adding 1" 3 /4" 1 /2" fittings and hose.
Adjust flow by turning flow control valve.
3
FOUNTAIN FLOW
CONTROL VALVE
Adjust fountain jet flow by
turning flow control valve.
4
FOUNTAIN BALL JOINT
Adjust the collar of the ball joint to enable the extensions to
be moved compensating for a uneven pond floor.
Tip:
Ensure that any fountain, waterfall, filter or feature fitted does not empty water out of
pond/water feature. In windy conditions it may be necessary to shut off or reduce the
height of your fountain display to prevent water loss. Also see the explanatory diagram on
the top face of your Amphibious pump carton.
30/3/06
INSTALLATION
1
2
13:33
Page 9
BELL AND TULIP
FOUNTAIN
4
Adjust Bell or Tulip
by moving head
higher for small
bell and lower for
a wider bell shape.
3
7