- ページ 4

スイッチ Blagdon POWERSAFE 2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Blagdon POWERSAFE 2 6 ページ。

ページを印刷する

INSTALLATION

IMPORTANT:

Please note all electrical work on garden lighting and power installations must

comply with part P of the building regulations. Failure to comply is a criminal offence. If the

installation of this product is not carried out by a competent electrician who is registered under

the Part P self-certification scheme then you must notify the local building control department

before work begins. For further information and guidance on this matter and other electrical

installations in your home that might be covered by the relevant legislation, contact your local

authorities building control department.

SWITCHBOX MOUNTING

The Switchbox should

be situated in a site

that is protected from:

•

Flooding

•

Extreme heat

•

Physical damage

•

Tampering by adults

children or pets

INSTALLATION STEP BY STEP

IMPORTANT:

Before removing the cover for wiring or adding additional appliances

to the Switchbox always ensure that the mains power supply is off and isolated.

Remove the Switchbox from the mounting bracket.

Unscrew the four screws at the back of the box to remove the Switchbox cover.

Place in a safe location.

INSTALLATION

Prepare the cable (see cable preparation diagram - inside front cover). A

maximum external cable diameter of 9mm is permitted.

IMPORTANT:

Please note that the mains input must be connected to the green power

input cable block only.

Switch one has a maximum loading of 1000w 1.0KW.

Switch two and subsequent switches are rated to a maximum wattage of 300w 0.3 KW.

These ratings must not be exceeded by the maximum wattage stated on the appliance to be

fitted to each switch.

Remove the cable gland cover and thread it over the cable of the appliance to be fitted. (see

gland detail diagram on colour Switchbox wiring diagram - inside front cover).

Note: The cable glands have a plug that should be retained if the gland is not being used for a

application. This should be inserted to maintain a weatherproof seal.

CIRCUIT BOARD

REMOVAL

Remove the circuit board by

unscrewing the locating screws and

wire each appliance before replacing

and locating into the box.