- ページ 11
無線アクセスポイント Blake UK PROCEPTION PROAPW300LのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Blake UK PROCEPTION PROAPW300L 20 ページ。 In-wall and ceiling high speed access points
Blake UK PROCEPTION PROAPW300L にも： 高度な指示 (15 ページ), マニュアル (2 ページ)
ページを印刷する
Advanced Settings Found in Gateway Mode
Some of the below setting are only found in gateway mode.
MAC ACL:- Access control lists (ACL) can control the traffic entering a network. When you configure ACL, you
can selectively admit or reject inbound traffic, thereby controlling access to your network or to specific resources
on your network.
Wi-Fi Timer Off:- Set the time to start and stop Wi-Fi access.
Advanced:- Country Region MUST be set to ETSI within the UK (For legal UK channel allocation).
2G and 5G mode sets the Wi-Fi standard of the AP.
Multicast Fast: - Provides the ability to minimize packet loss in a network when there is a link or node failure by
enhancing but not changing multicast routing
protocols.
Maximum per AP: - Number of permitted on the AP. Prevents over loading and therefore slowing down of the
AP.
WLAN Partition: - Enabling WLAN Partition prevents associated wireless clients from communicating with each
other for security.
Short GI: - Short Guard Interval can increases the data rate by up to 10%.
Coverage Threshold: - The signal level at the point where the AP drops the device.
TX Power: - Be careful with this setting, it can reduce the channel overlap and degrade the Wi-Fi signal if using
with more than one AP. Especially useful when roaming and set with coverage threshold.
Preferred 5G: - Preferred 5G is a feature in a Wi-Fi access point that prioritizes 5G network connections,
providing faster speeds and lower latency than traditional 2.4GHz networks
DFS:- When support for DFS is enabled, it will be necessary for Wi-Fi access points to verify that any radar in
proximity is not using DFS frequencies. This process is called Channel Availability Check, and it is executed
during the boot process of the AP as well as during its normal operations. If the AP detects that a radar is using a
particular DFS channel, then it will exclude that channel from the list of available channels. This state will last for
30 minutes, after which the AP will check again if the channel can be used for Wi-Fi transmissions. The Channel
Availability Check performed during the boot process can take anywhere between 1 and 10 minutes, depending
on which country you're in. For this reason, DFS channels are not immediately available when an AP boots. Wi-Fi
networks that are servicing real-time and mission-critical applications may want to avoid such disconnections
caused by DFS frequencies.
VAP 1-3: - In each of the 2G & 5G sections you can allocate up to three VAPs (Virtual Access points). This is
ideal for when you want to give guests or visitors access to Wi-Fi but for security, don't want to give them your
usual password. You can setup with a temporary VAP SSID and password and simply remove when finished.
The VAP user will not be able to scan or see other devices on your network.
11 Blake UK Ltd. 177-187 Rutland Road, Sheffield, South Yorkshire S3 9PT | 0114 223 5000 | www.blake-uk.com