- ページ 2

エクササイズバイク 3D innovations DeskCycleのPDF マニュアルをオンラインで閲覧またはダウンロードできます。3D innovations DeskCycle 3 ページ。 Using the large display manual
3D innovations DeskCycle にも：オーナーズマニュアル (12 ページ), ユーザーマニュアル (16 ページ)

ページを印刷する

Using the Large Display

How to Turn the Display On and Off

The display turns on automatically when you

pedal the bike. You can also turn the display

on by pressing the Function Button.

The display will turn off automatically a few

minutes after you stop pedaling.

The Function Button

Press this button to change what is displayed

by the Large Numerals. You also use this

button to reset the display.

How to Reset the Display

The display keeps track of the Time, Distance

and Calories. To reset these all to zero, press

and hold the Function Button for at least 3

seconds.

The Mode Indicaors

The Mode is shown at the bottom of the display window. The Mode determines what is

displayed by the Large Numerals.

In the picture, the selected mode is TMR. This means that the Large Numerals display the

Timer value. Press the function button to switch between modes.

All Modes are listed below.

TMR – Timer: Total time pedaled since the display was last reset.

SPD – Speed: Pedal speed in miles per hour.

DST – Trip Distance: Total miles pedaled since the display was last reset.

CAL – Calories: Estimated calories burned since the display was last reset.

ODO – Odometer: Total distance pedaled in miles. Does not reset.

SCAN – Scan Mode: When the SCAN indicator is visible, the display will cycle through

each mode. Each mode (TMR, SPD, DST, CAL, ODO) is displayed for about 5 seconds.

The difference between the DST and the ODO modes is that the Odometer (ODO) does not

clear to zero when you press the reset button.

The STOP Indicator

In the lower left hand corner of the display is the pedaling indicator.

The word

STOP

will be displayed when you are not pedaling.

This should not be visible when you are pedaling.