リモコン Dish Network ViP 211 SeriesのPDF セットアップ方法をオンラインで閲覧またはダウンロードできます。Dish Network ViP 211 Series 2 ページ。 Quick facts; quick remote control programming & tips for installers
Dish Network ViP 211 Series にも：カスタマイズ・マニュアル (10 ページ), クイック・リファレンス・マニュアル (2 ページ), はじめに (2 ページ), マニュアル (2 ページ)

ページを印刷する

DISH receivers will often not show when they are on signal if they have incorrect "Check Switch"

information. For this reason, DISH users must clear current settings before pointing. To do this for most

DISH receivers, follow these steps. The following instructions are based on a ViP

If your receiver differs from the options shown, you may need to consult your receiver manual. The

wording and display used in your receiver may differ slightly.

DISH

Receiver Setup for MP1

For Help, Call 1-800-788-4417

Before starting,

disconnect coax

from "Sat in" on

back of receiver.

Press Menu on

your remote.

Select option 6,

System Setup.

Select option 1,

Point Dish.

Check that there

are no checkmarks

by SuperDISH or

Alternate. Select

Test.

This should clear

out any previously

installed devices.

Then, select Done.

Re-connect the

coaxial cable to

the "Satellite In"

port on the back

of the receiver.

Antenna

™

211 receiver.

Select option 1,

Installation.

Select

Check Switch.

The receiver will

go through a

number of steps

and then may

warn that fewer

satellites were

detected.

If so, select Save.

It may ask you to

confirm. If so,

select Save again.