- ページ 5

アンテナ Dish Network PlaymakerのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dish Network Playmaker 8 ページ。 Portable automatic satellite tv antennas

ページを印刷する

Updating Receiver Software

For optimal performance, update receiver software occasionally. To

allow the software to update, leave the satellite on signal, and press

the power button on the remote or front panel of the receiver; this

will put the receiver in Standby mode (figure 8). Do not unplug

the receiver at this time.

Figure 8

After being in Standby mode for a few minutes, the software

will automatically begin to update (figure 9). Upon completion

of the update, the receiver will reboot. Return to the beginning

of "Receiver Setup for Currently Active or Previously Used

Receivers" to re-acquire satellites and complete setup.

Figure 9

TIP

If the receiver is in Standby mode for more than five minutes,

no software update is necessary. Turn the receiver back on to

resume normal operation

NOTE

If the receiver reboots at this time, restart (see figures 1 & 2).

Receiver Setup for Currently Active or

Previously Used Wally

If the receiver you will be using with the DISH

Playmaker

Dual antenna is an older receiver that has not been

used in several years, you may need to connect the receiver to a

DISH home satellite to be updated before proceeding with the

mobile setup.

After the receiver has been powered on, the receiver will enter

the Mobile Setup menu.

NOTE

If mobile setup menu does not appear, press and hold power button on

the front panel of the receiver for 3 seconds to reset the receiver.

Receiver

Playmaker

/ DISH

Select the satellite configuration WA 1 TV (110, 119, 129).

OS 2.1 will allow an alternate selection of satelites from DISH

western arc WA 1 TV (61.5,110,119) exclusively with a Wally

receiver (figure 10).

Figure 10

The satellite will begin searching and will locate the desired

satellites (figure 11).

Figure 11

TIP

If prompted with a message stating fewer satellites than previously used

were found, select SAVE or YES to continue.

After the satellites have been acquired, the Electronic

Programming Guide will download (figure 12).

Figure 12

Receiver setup instructions are accurate at time

of printing and may change without notice.