- ページ 5

アンプ Acoustic B100のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Acoustic B100 8 ページ。 Bass guitar amps
Acoustic B100 にも：ユーザーマニュアル (13 ページ)

B100 MKII FRONT PANEL

1. Bass Input: ¼" two-conductor jack

2. -10 dB pad: Reduces input sensitivity for use with active electronics basses or high output pickups

3. Gain: Adjusts the level of preamp input gain

4. Clipping Light: Lights in red when hi gain creates preamp clipping

5. Overdrive: Controls the amount of overdrive

6. On/Off Switch: Activates the Overdrive circuit

7. Overdrive Level: Controls the mix of overdrive to clean signal

8. Volume: Adjusts the overall volume level of the amplifier

9. Notch: Adjusts the -10dB notch frequency from 50Hz to 1kHz

10. Shape: This button decreases the level of the mid frequencies creating an alternate EQ curve

11. Low: This control increases or decreases bass frequencies

12. Low Mid: This control increases or decreases low midrange frequencies

13. High Mid: This control increases or decreases high midrange frequencies

14. High: This control increases or decreases treble frequencies

15. Aux In: This 3-conductor ⅛" media input jack will allow you to plug in a CD, MP3 player, or any other source so you can practice

along. To control the volume of the source, adjust the output volume of the device. Note: Turn the volume all the way down

before plugging in your guitar and adjust the volume according to your taste.

16. Headphone Output: ⅛" 3-conductor jack for plugging in headphones. When used, it will disconnect the internal speaker

17. Power Switch: When lit, the amplifier is on and ready for use.

B100 MKII BACK PANEL

1. Direct Output: XLR direct balanced output connector jack

2. Pre/Post EQ Switch: Switches Direct Output between pre and post EQ operation

3. Effects Send: ¼" two-conductor jack sends signal to an external effects or signal processing device

4. Ground Lift: Lifts the ground from the XLR direct output. Useful for eliminating hum when the direct out is used

5. Direct Output Level: Adjusts the level of the direct output signal

6. Effects Return: ¼" two-conductor jack returns signal from an external effects or signal processing device

9778 B15 B30 B100MKII B200MKII B450MKII Owner's Manual.indd 5

B15, B30, B100 MKII, B200 MKII, B450 MKII

OWNER'S MANUAL

15 16

www.acousticamplification.com

7/13/12 4:22 PM