- ページ 4
フォグマシン Disinfect&Fog Heavy Duty ULV FoggerのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Disinfect&Fog Heavy Duty ULV Fogger 8 ページ。
ページを印刷するHeavy Duty ULV Fogger Ownership Manual
How To Use
•
Remove the cap for the bottle, add in desired amount of
disinfectant, and close cap clockwise until sealed.
•
If bottle is disconnected from the main body of the fogger,
reattach by inserting until latched (top latch).
•
Ensure the control knob for Disinfectant is set (turned) to the
"Close" position.
•
Plug the fogger into a standard 120V outlet.
•
Hold the fogger by the handle or use the should strap. Push the
progressive power slide switch to the desired position to turn on
the fogger.
•
The fogger will blow air only. Slowly turn the Disinfectant knob
towards the "Open" position. The disinfectant should be seen at the
output. Refer to the Disinfect & Fog training videos for more info
on best practices using this fogger (see Resources section).
After use:
•
Leaving the slide switch "on", turn the disinfectant know to "close",
allowing the residual disinfectant to be drained from the machine
(approx. 5-10 seconds).
•
Turn o! the slide switch to turn o! the fogger.
•
Push the lever at the top of the bottle (tank) to disconnect the
bottle from the fogger main body. This will release any built-up
pressure that may exist after use.
•
Turn on the slide switch and ensure any residual disinfectant is
drained from the main body. Turn o! the slide switch when
completed.
•
The bottle (tank) can be reconnected to the main body for next
use.
Resources
www.disinfectandfog.com/training-videos
Page 2