- ページ 7
3Dプリンター 3D Systems CubeX TrioのPDF プリントチップ交換をオンラインで閲覧またはダウンロードできます。3D Systems CubeX Trio 7 ページ。
ページを印刷するSlowly raise the print pad until the print tip is touching it.
5
Continue raising the print pad until there is approximately 0.5mm between the print pad and the CubeX
wiping stick.
6
Turn the CubeX printer off and unplug it from the mains power supply.
7
Using the 2.5mm hex driver, tighten the print tip holding bolt (pictured) to lock the print jet in place.
8
With the print tip fastened you can now turn on the CubeX printer and start printing.