- ページ 2

ディスペンサー Dispense-Rite SLR-LID-2 SeriesのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Dispense-Rite SLR-LID-2 Series 2 ページ。

SECTION TWO - LOADING AND OPERATION

To load the dispenser the cover ring must be removed.

Turn the ring bezel counter clockwise to remove from

dispenser.

Load a full sleeve of lids with the bottom side of the

lids facing outward.

Important note: do not load lids in the wrong direction

or they will not discharge properly.

While holding lids in place with your hand replace cover

ring and turn clockwise to reattach to the dispenser.

To remove lids grasp the rim and pull straight out of

opening.

ALTERNATIVE FACEPLATE

Depending on the specific lid dispenser model ordered the

unit may have been supplied with an alternative lid

dispensing faceplate. The alternative faceplate is for use

with lids that are difficult to remove from the standard

faceplate. To utilize the alternative faceplate simply remove

the ring bezel, replace the faceplate insert and re-install the

ring bezel onto the dispenser as shown below.

LID DISPENSING PERFORMANCE TIPS

1. Always load lids with the bottom side of the lid facing

outward so that you may grasp the lid to remove.

2. This lid dispenser is intended primarily for use with flat

beverage lids only. Lids that are tightly nested or deeply

extruded may not be compatible with this product.

3. Never overfill the dispenser as it may increase the

difficulty of removing lids.

Diversified Metal Products, Inc.

2205 Carlson Drive • Northbrook, IL 60062 • (847) 753-9595 • fax (847) 753-9648