ディスペンサー Dispense-Rite SLRB-2MDのPDF インストレーション＆バッフル選択手順をオンラインで閲覧またはダウンロードできます。Dispense-Rite SLRB-2MD 2 ページ。

INSTALLATION & BAFFLE SELECTION INSTRUCTIONS

The cup dispenser is completely assembled but it will require the proper size silicone baffle be inserted once the

dispenser has been installed. A full sleeve of cups is recommended for dispenser installation and baffle selection.

If an extra spring was included in the box, you must first decide which spring to use for your application.

To dispense paper or plastic cups in a horizontal mounting position or foam cups in any mounting position use the

spring already installed inside the cup dispenser -- proceed to BAFFLE SELECTION AND INSTALLATION.

To dispense paper or plastic cups in a vertical or angled mounting position the heavier compression spring will be

required. Remove the dispenser's end cap and replace the spring with the one packaged separately with the

dispenser (marked with an orange label) -- proceed to BAFFLE SELECTION AND INSTALLATION.

SECTION ONE - CUP DISPENSER INSTALLATION

Cut a 5-1/4" diameter hole into the desired

mounting surface.

Rotate the cover ring counterclockwise and

remove from the dispenser. Remove the

cardboard spacer insert and discard.

DISPENSE-RITE

5-1/4"

132 mm

134 mm

Diversified Metal Products, Inc.

2205 Carlson Drive • Northbrook, IL 60062 • (847) 753-9595 • fax (847) 753-9648

www.dispense-rite.com • [email protected]

SLR-2 SERIES

3. Insert the dispenser into the mounting hole.

Align the "UP" mark to the top in a horizontal or

angled application and to the rear in a vertical

mounting application.

4. Drill four 9/64" pilot holes in the locations shown

below. Fasten the dispenser with the four #10

screws provided.