計測機器 Abbott FreeStyle Libre 2のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Abbott FreeStyle Libre 2 2 ページ。 Flash glucose monitoring system 4.5”
Abbott FreeStyle Libre 2 にも： スタート (9 ページ), クイック・スタート・マニュアル (2 ページ), スタート (15 ページ), マニュアル (12 ページ), スタート (15 ページ)
ページを印刷する
FLASH GLUCOSE MONITORING SYSTEM
Quick Start Guide for
FreeStyle Libre 2 Reader
●
1
Assemble and Apply Sensor to the back of your upper arm
STEP 1
Select site on back of upper arm.
Do not use other sites as these may
result in inaccurate glucose readings.
Note:
Avoid scars, moles, stretch
marks, lumps, and insulin injection
sites. To prevent skin irritation,
rotate sites between applications.
STEP 4
Line up dark mark on Sensor
Applicator with dark mark on
Sensor Pack. On a hard surface,
press down firmly on Sensor
Applicator until it comes to a stop.
STEP 7
Place Sensor Applicator over site
and push down firmly to apply
Sensor.
CAUTION:
Do not push down on
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Setup Overview
Refer to your User's Manual for full System instructions and information.
Reader
USB Port
Sensor
Pack
Codes on labels
must match
STEP 2
Wash site using a plain soap,
dry, and then clean with alcohol
wipe. Allow site to air dry before
proceeding.
STEP 5
Lift Sensor Applicator out of
Sensor Pack.
STEP 8
Sensor
Gently pull Sensor Applicator
away from your body.
●
1
Touchscreen
Home Button
●
2
Sensor
Applicator
●
3
CODE XXX
Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION:
must match on Sensor Pack
and Sensor Applicator or
glucose readings will be
incorrect.
Assemble and Apply
Sensor to your body
Start new Sensor with Reader
Wait 60 minutes
for start-up
Check your glucose whenever you
want for up to 14 days.
STEP 3
Cap
Lid
Sensor codes
Sensor Pack | Envase del sensor
Customer Service | Atención al clien
CODE
STEP 6
Sensor Applicator is ready to
apply Sensor.
CAUTION:
Sensor Applicator
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
STEP 9
Make sure Sensor is secure.
Discard used Sensor Applicator
and Sensor Pack according to
local regulations.
1-855-632-8658
XXX
XXXXXXXXXXX
YYYY-MM-DD